T60-ACR
CHT GAUGE
CHT GAUGE
The T60-ACR CYLINDER HEAD TEMPERATURE GAUGE is compatible with rotax 912S / 914 Series engine, supplied with the 1000-75 OHM ( 68F-320F ) Temperature Sensor. LOW and HIGH Temp Alarms can be set over the entire range of the instrument/sender. When activated, the built-in 85dB alarm will sound and the display will flash. The alarm can be enabled or disabled with a single key press. Five levels of backlighting can be selected. Then all setup, calibration constants, alarm values, sender type and lighting level selected are saved to nonvolatile memory. Terminal C can be programmed as an External Alarm output. This could be used in conjunction with an ER-1A electronic relay to control optional equipment such as an electric radiator cooling fan, or to simply activate a warning/annunciator light on your panel.
T60-ACR CHT Gauge Specifications
Power Supply: 9.5 - 33.0 VDC, (.018 amp nominal)
Operating Temp: 32 - 122F (0-50C)
Size/ Weight: 2.475” square bezel, with standard aviation 2.250”
raised round ring. Standard 2.625” diameter
mounting hole layout at 45 degrees. Unique bezel
design allows user either front or rear mounting in
your panel. Gauge depth behind panel: surface
mounted approx 2.60”, rear mounted, approx.
2.90”. Weight approx 2.3 oz.
Accuracy: Better than +/-1 digit, front panel adjustable
calibration.
Senders: Built-in calibration curves for most 15-250 ohm
oil/water temperature senders such as VDO,
Compatible with the 1000-75 OHM Factory 912S/914
series Rotax Cylinder Head Temp sender.
Alarms: LOW and HIGH alarms user settable from 32-300 F
Display: 3 digit, degrees in Fahrenheit or Celsius, Five levels
of backlighting
Output: Terminal C is Factory preset, and can be used as an
External Alarm signal to control an ER-1A or a panel
warning light.
Power Supply: 9.5 - 33.0 VDC, (.018 amp nominal)
Operating Temp: 32 - 122F (0-50C)
Size/ Weight: 2.475” square bezel, with standard aviation 2.250”
raised round ring. Standard 2.625” diameter
mounting hole layout at 45 degrees. Unique bezel
design allows user either front or rear mounting in
your panel. Gauge depth behind panel: surface
mounted approx 2.60”, rear mounted, approx.
2.90”. Weight approx 2.3 oz.
Accuracy: Better than +/-1 digit, front panel adjustable
calibration.
Senders: Built-in calibration curves for most 15-250 ohm
oil/water temperature senders such as VDO,
Compatible with the 1000-75 OHM Factory 912S/914
series Rotax Cylinder Head Temp sender.
Alarms: LOW and HIGH alarms user settable from 32-300 F
Display: 3 digit, degrees in Fahrenheit or Celsius, Five levels
of backlighting
Output: Terminal C is Factory preset, and can be used as an
External Alarm signal to control an ER-1A or a panel
warning light.